Dell PowerEdge R750xa EMC Installation and Service Manual - Page 95
Removing the expansion card riser Riser 2, Installing the Riser 2 blank
![]() |
View all Dell PowerEdge R750xa manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 95 highlights
Figure 83. Removing the expansion card riser (Riser 2) 3. If the risers are not going to be replaced, install riser blanks and tighten the captive screws. NOTE: You must install a filler bracket over an empty expansion card slot to maintain Federal Communications Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the system and aid in proper cooling and airflow inside the system. Figure 84. Installing the Riser 2 blank Installing and removing system components 95
![](/manual_guide/products/dell-poweredge-r750xa-emc-installation-service-manual-e03ec2d/95.png)
Figure 83. Removing the expansion card riser (Riser 2)
3.
If the risers are not going to be replaced, install riser blanks and tighten the captive screws.
NOTE:
You must install a filler bracket over an empty expansion card slot to maintain Federal Communications
Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the system and aid in
proper cooling and airflow inside the system.
Figure 84. Installing the Riser 2 blank
Installing and removing system components
95