Garmin GNC 420W Pilots Guide - Page 102

SECTION 6 PROCEDURES Selecting 'VECTORS' from the Transitions Window: 1) Select Billard Municipal (KTOP) as the destination, using the Direct-to Key, or as the last waypoint in a flight plan. 2) Press the PROC Key and select the 'VOR 22' approach using the steps outlined in Section 6.1. 3) From the Transitions Window, select 'VECTORS' (Figure 6-49). 3) From the Transitions Window, select 'D258G' as the IAF (Figure 6-50). Also, select 'Load?'. Figure 6-50 Transitions Window 4) When cleared, press the PROC Key and select 'Activate Vector-To-Final?' (Figure 6-51). Figure 6-49 Transitions Window 4) Select 'Load?' (or 'Activate?', if already cleared for the approach). Activating vectors-to-final from the Procedures Page: 1) Select Billard Municipal (KTOP) as the destination, using the Direct-to Key or as the last waypoint in a flight plan. 2) Press the PROC Key and select the 'VOR 22' approach using the steps outlined in Section 6.1. Figure 6-51 Procedures Page Flying the Vectors Approach With 'vectors to final' selected, the CDI needle remains off center until the aircraft is established on the final approach course. With the approach activated, the Map Page displays an extension of the final approach course in magenta (magenta is used to depict the active leg of the flight plan) and 'VTF' appears as part of the active leg on the Default NAV Page (as a reminder that the approach was activated with vectors-to-final). 6-18 GNC 420(A) Pilot's Guide and Reference 190-00140-20 Rev. K