Garmin GNC 420W Pilots Guide - Page 222
View the Data Link Status SAT ID/CONNECTIVITY FIELD, MESSAGE, DESCRIPTION
![]() |
View all Garmin GNC 420W manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 222 highlights
SECTION 11 ADDITIONAL FEATURES Monitoring the Data Link The Data Link Status Page provides an indication of the integrity of the Data Link. The Data Link Page allows the pilot to monitor the system and determine the possible cause of a failure. View the Data Link Status Page: 1) From the AUX Page Group, select the Data Link Page. 2) Highlight 'Data Link Status' and press the ENT Key. 3) The Data Link Status Page (Figure 11-47) is displayed. SAT ID/CONNECTIVITY FIELD MESSAGE DESCRIPTION '_ _ _' RS-232 communication with the GDL 49 has been lost. 'Data Link has failed' There is a disconnect inside the GDL 49. 'Linked to sat' Can exchange data with the satellite. 'Satellite in view' Found satellite but have not yet identified it. 'Searching...' No satellite is currently in view. Table 11-8 Sat ID/Connectivity Field • SATCOM Operation - This field indicates the current activity being performed by the satellite communicator within the GDL 49. Table 11-9 lists the messages that can be displayed, including interpretations of the most common ones: Figure 11-47 Data Link Status Page The GDL 49 Datalink Status Page shows the following fields: • TX Queue - Shows the number of requests in the GDL 49's transmit queue waiting to be sent to the satellite. • RX Queue - Shows the number of responses in the GDL 49's receive queue waiting to be sent to the GNC 420. • Sat ID/Connectivity - Shows the current satellite in view and also indicates the status of the current satellite connection. See Table 11-8. SATCOM OPERATION FIELD MESSAGE DESCRIPTION '_ _ _' Unknown task is being performed, or RS-232 communication with the GDL 49 has been lost. 'Idle' Waiting to perform the next task. 'Receiving message' Receiving a response from the satellite. 'Sending message' Transmitting a message. 'Sending request' Transmitting a request to the satellite. Table 11-9 SATCOM Operation Field • SATCOM SER NUM - This field shows the serial number assigned to the GDL 49's internal satellite communicator. • GDL SW - This field shows the currently installed software version for the GDL 49. 11-32 GNC 420(A) Pilot's Guide and Reference 190-00140-20 Rev. K
![](/manual_guide/products/garmin-gnc-420w-pilots-guide-8f6f648/222.png)