Garmin GNC 420W Pilots Guide - Page 242
Removing the NavData or Terrain Data Card, A-2, Grasp the top and bottom surfaces of
![]() |
View all Garmin GNC 420W manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 242 highlights
APPENDIX A DATA CARD USE Removing the NavData or Terrain Data Card (Figure A-2): 1) Gently press on the tab-using a slight upward motion-at the front center of the data card. This partially deploys the swing arm handle. 2) Rotate the swing arm handle upward (and outward) until it locks into place, perpendicular to the face of the GNC 420 unit. 3) Grasp the top and bottom surfaces of the swing arm handle between your thumb and forefinger, and pull directly away from the face of the GNC 420 unit to remove the data card. A-2 GNC 420(A) Pilot's Guide and Reference 190-00140-20 Rev. K
![](/manual_guide/products/garmin-gnc-420w-pilots-guide-8f6f648/242.png)
GNC 420(A) Pilot’s Guide and Reference
APPENDIX A
DATA CARD USE
A-2
Removing the NavData or Terrain Data Card
(Figure A-2):
1)
Gently press on the tab—using a slight upward
motion—at the front center of the data card.
This partially deploys the swing arm handle.
2)
Rotate the swing arm handle upward (and
outward) until it locks into place, perpendicular
to the face of the GNC 420 unit.
3)
Grasp the top and bottom surfaces of the
swing arm handle between your thumb and
forefinger, and pull directly away from the
face of the GNC 420 unit to remove the data
card.
190-00140-20
Rev. K