Garmin GNC 420W Pilots Guide - Page 15

SECTION 1 INTRODUCTION Viewing the Checklists Page: 1) Turn the large right knob to highlight 'Go To Chklist?' (Figure 1-9) and press the ENT Key. Figure 1-7 Fuel Flow Selected The Instrument Panel Self-test Page includes selections to set fuel on board (FOB) to full capacity and access the Checklists Page. This allows the pilot to quickly set fuel to full limits and display any checklists that have been entered, such as start up or takeoff checklists. Setting fuel on board to full (if not provided by sensor): 1) Turn the large right knob to highlight 'Set Full Fuel?' (Figure 1-8). Figure 1-8 'Set Full Fuel?' Highlighted 2) Press the ENT Key and verify that fuel on board ('FOB') now matches the fuel capacity (CAP) figure. Fuel on board is reduced, over time, based on the fuel flow (FF) figure. Figure 1-9 'Go To Chklist?' Highlighted 2) Turn the large right knob to select the desired checklist, then execute each step (Section 9.3, Utility Page: Checklists) in the selected checklist. 3) After completing the desired checklist(s), press the small right knob to return to the Checklists Page. Press the small right knob again to return to normal operation on the Satellite Status Page or the Map Page. 4) Once instrument operation has been verified with the Instrument Panel Self-test Page displayed, press the ENT Key. NOTE: The GNC 420 can hold up to nine checklists with up to 30 entries in each checklist. 190-00140-20 Rev. K GNC 420(A) Pilot's Guide and Reference 1-7