Garmin GNC 420W Pilots Guide - Page 89
Direct-to, COM Flip-flop, From the Transitions Window
View all Garmin GNC 420W manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 89 highlights
The steps required to set up and fly the approach are detailed below (refer to Figure 6-9 for the following steps): 1) Prior to departing KFDK, the destination (KLYH) is selected using the Direct-to Key or by creating a flight plan terminating at Lynchburg Regional. 2) While enroute to KLYH, select the ATIS frequency from the list on the NAV/COM Page (Section 3.6 and Figure 6-10) and place it in the standby field of the COM Window. Use the COM Flip-flop Key to make the ATIS frequency active. SECTION 6 PROCEDURES 3) Press the PROC Key (Figure 6-11) and select the 'VOR 03' approach using the steps outlined in Section 6.1. Figure 6-11 Procedures Page 4) From the Transitions Window (Figure 6-12), select LYH VOR (the IAF). Also, select 'Load?' to load, but not activate, the approach. Figure 6-10 NAV/COM Page Figure 6-12 Approach and Transitions Windows 5) Press the PROC Key, select 'Activate Approach?' and press the ENT Key to activate the approach. 190-00140-20 Rev. K GNC 420(A) Pilot's Guide and Reference 6-5