Garmin GNC 420W Pilots Guide - Page 178
Setup 2 Nearest Airport Criteria, Setup 2 COM Configuration
View all Garmin GNC 420W manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 178 highlights
SECTION 9 AUX PAGES Setup 2 Page: Nearest Airport Criteria Setting the minimum runway length and runway surface: 1) Select 'Nearest Airport Criteria' from the Setup 2 Page, using the steps described at the beginning of this section. 2) The flashing cursor highlights the runway surface field (Figure 9-76). Turn the small right knob to select the desired surface. The following options are available: • Any surface • Hard surfaces only • Hard or Soft surfaces • Water landings only Figure 9-77 Minimum Runway Length Field Selected Setup 2 Page: COM Configuration Setting the COM channel spacing: 1) Select 'COM Configuration' from the Setup 2 Page, using the steps described at the beginning of this section. 2) The flashing cursor highlights the channel spacing field (Figure 9-78). Turn the small right knob to select the desired channel spacing: 8.33 kHz or 25.0 kHz. Press the ENT Key when finished. Figure 9-76 Surface Type Window 3) Press the ENT Key to accept the runway surface selection. 4) The flashing cursor moves to the minimum runway length field (Figure 9-77). To enter a different minimum runway length, use the small and large right knobs to enter the desired length. Press the ENT Key when finished. Figure 9-78 Channel Spacing Window 9-30 GNC 420(A) Pilot's Guide and Reference 190-00140-20 Rev. K