HP 6125XLG R2306-HP 6125XLG Blade Switch Network Management and Monitoring Com - Page 103
snmp-agent sys-info contact
View all HP 6125XLG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 103 highlights
Usage guidelines The snmp-agent source command enables the SNMP agent to use the primary IP address of an interface as the source IP address in all its SNMP informs or traps, regardless of their outgoing interfaces. An NMS can use this IP address to filter all the informs or traps sent by the SNMP agent. Make sure the specified interface has been created and assigned a valid IP address. The configuration will fail if the interface has not been created and will take effect only after a valid IP address is assigned to the specified interface. Examples # Configure the primary IP address of Ten-GigabitEthernet 1/1/5 as the source address of SNMP traps. system-view [Sysname] snmp-agent trap source ten-gigabitethernet 1/1/5 # Configure the primary IP address of Ten-GigabitEthernet 1/1/6 as the source address of SNMP informs. system-view [Sysname] snmp-agent inform source ten-gigabitethernet 1/1/6 Related commands • display snmp-agent community • snmp-agent target-host • snmp-agent trap enable snmp-agent sys-info contact Use snmp-agent sys-info contact to configure the system contact. Use undo snmp-agent sys-info contact to restore the default contact. Syntax snmp-agent sys-info contact sys-contact undo snmp-agent sys-info contact Default No system contact is configured. Views System view Predefined user roles network-admin Parameters sys-contact: Specifies the system contact, a string of 1 to 200 characters. Usage guidelines Configure the system contact for system maintenance and management. Examples # Configure the system contact as Dial System Operator # 27345. system-view 101