HP 6125XLG R2306-HP 6125XLG Blade Switch Network Management and Monitoring Com - Page 150
sflow sampling-rate, sflow source, Related commands, Syntax, Default, Views, Predefined user roles
View all HP 6125XLG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 150 highlights
system-view [Sysname] interface ten-gigabitethernet1/1/5 [Sysname-Ten-GigabitEthernet1/1/5] sflow sampling-mode determine Related commands sflow sampling-rate sflow sampling-rate Use sflow sampling-rate to specify the number of packets out of which flow sampling will sample a packet on an interface. Use undo sflow sampling-rate to disable flow sampling. Syntax sflow sampling-rate rate undo sflow sampling-rate Default Flow sampling samples no packet. Views Ethernet interface view Predefined user roles network-admin Parameters rate: Specifies the number of packets out of which flow sampling will sample a packet on the interface. The value range is 1000 to 500000. Examples # Enable flow sampling to sample a packet out of 4000 packets on Ten-GigabitEthernet 1/1/5. system-view [Sysname] interface ten-gigabitethernet 1/1/5 [Sysname-Ten-GigabitEthernet1/1/5] sflow sampling-rate 4000 Related commands sflow sampling-mode sflow source Use sflow source to specify the source IP address of sFlow packets. Use undo sflow source to remove the specified source IP address. Syntax sflow source { ip ip-address | ipv6 ipv6-address } * undo sflow source { ip | ipv6 } * Default The source IP address of sent sFlow packets is determined by routing. 148