HP 6125XLG R2306-HP 6125XLG Blade Switch Network Management and Monitoring Com - Page 22

Table 7 Command output Field source reference stra reach poll now offset delay disper [12345] Total sessions Description • When the reference clock is the local clock, the field displays LOCAL (number), which indicates that the IP address of the local clock is 127.127.1.number, where number represents the NTP process number in the range of 0 to 3. • When the reference clock is the clock of another device, the field displays the IP address of the NTP server. Reference clock ID of the NTP server: • If the reference clock is the local clock, the value of this field is related to the value of the stra field: { When the value of the stra field is 0 or 1, this field displays LOCL. { When the stra field has another value, this field displays the IP address of the local clock. • If the reference clock is the clock of another device on the network, this field displays the IP address of the device. Stratum level of the clock source, which determines the clock accuracy. The value is in the range of 1 to 16. The clock accuracy decreases from stratum 1 to stratum 16. A stratum 1 clock has the highest precision, and a stratum 16 clock is not synchronized and cannot be used as a reference clock. Reachability count of the clock source. 0 indicates that the clock source is unreachable. Polling interval in seconds. It is the maximum interval between successive NTP messages. Length of time from when the last NTP message was received or when the local clock was last updated to the current time. Time is in seconds by default. If the time length is greater than 2048 seconds, it is displayed in minutes. If greater than 300 minutes, in hours. If greater than 96 hours, in days. Offset of the system clock relative to the reference clock, in milliseconds. Roundtrip delay from the local device to the NTP server, in milliseconds. Maximum error of the system clock relative to the reference source, in milliseconds. • 1-Clock source selected by the system (the current reference source). It has a system clock stratum level less than or equal to 15. • 2-The stratum level of the clock source is less than or equal to 15. • 3-The clock source has survived the clock selection algorithm. • 4-The clock source is a candidate clock source. • 5-The clock source was created by a configuration command. Total number of associations. # Display detailed information about all IPv4 NTP associations. display ntp-service sessions verbose Clock source: 192.168.1.40 Session ID: 35888 Clock stratum: 2 Clock status: configured, master, sane, valid 20