HP 6125XLG R2306-HP 6125XLG Blade Switch Network Management and Monitoring Com - Page 107
snmp-agent trap enable, Usage guidelines, Examples, Related commands, Syntax, Default, Views
View all HP 6125XLG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 107 highlights
Usage guidelines SNMPv1 and SNMPv2c settings are supported only in non-FIPS mode. You can specify multiple SNMP notification target hosts. Make sure the SNMP agent uses the same UDP port for SNMP notifications as the target host. Typically, NMSs, for example, IMC and MIB Browser, use port 162 for SNMP notifications as defined in the SNMP protocols. If none of the keywords v1, v2c, or v3 is specified, SNMPv1 is used. Make sure the SNMP agent uses the same SNMP version as the target host so the host can receive the notification. If neither authentication nor privacy is specified, the security model is no authentication, no privacy. Examples # Configure the SNMP agent to send SNMPv1 traps to 10.1.1.1 in the community public. system-view [Sysname] snmp-agent trap enable standard [Sysname] snmp-agent target-host trap address udp-domain 10.1.1.1 params securityname public v1 Related commands • snmp-agent source • snmp-agent trap enable • snmp-agent trap life snmp-agent trap enable Use snmp-agent trap enable to enable SNMP notifications globally. Use undo snmp-agent trap enable to disable SNMP notifications globally. Syntax snmp-agent trap enable [ bgp | configuration | ospf [ authentication-failure | bad-packet | config-error | grhelper-status-change | grrestarter-status-change | if-state-change | lsa-maxage | lsa-originate | lsdb-approaching-overflow | lsdb-overflow | neighbor-state-change | nssatranslator-status-change | retransmit | virt-authentication-failure | virt-bad-packet | virt-config-error | virt-retransmit | virtgrhelper-status-change | virtif-state-change | virtneighbor-state-change ] * | standard [ authentication | coldstart | linkdown | linkup | warmstart ] * | system ] undo snmp-agent trap enable [ bgp | configuration | ospf [ authentication-failure | bad-packet | config-error | grhelper-status-change | grrestarter-status-change | if-state-change | lsa-maxage | lsa-originate | lsdb-approaching-overflow | lsdb-overflow | neighbor-state-change | nssatranslator-status-change | retransmit | virt-authentication-failure | virt-bad-packet | virt-config-error | virt-retransmit | virtgrhelper-status-change | virtif-state-change | virtneighbor-state-change ] * | standard [ authentication | coldstart | linkdown | linkup | warmstart ] * | system ] Default SNMP notifications are enabled for every module. Views System view 105