HP 6125XLG R2306-HP 6125XLG Blade Switch Network Management and Monitoring Com - Page 109
Table 27, Standard SNMP notifications, standard, Keyword, Definition, system, snmp-agent trap enable
View all HP 6125XLG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 109 highlights
virt-authentication-failure virt-bad-packet virt-config-error virt-retransmit virtgrhelper-status-change virtif-state-change virtneighbor-state-change ospfVirtIfAuthFailure ospfVirtIfRxBadPacket ospfVirtIfConfigError ospfVirtIfTxRetransmit ospfVirtNbrRestartHelperStatusChange ospfVirtIfStateChange ospfVirtNbrStateChange Notifications for authentication failures on OSPF virtual interfaces. Notifications for OSPF packets received on a virtual interface. Virtual interface configuration error notifications. Notifications generated if OSPF packets are received or forwarded on a virtual interface. Notifications for neighbor GR Helper status changes of a virtual interface. Virtual interface status change notifications. Notifications generated if the neighbor status of a virtual interface has changed. standard: Specifies SNMP standard notifications. Table 27 Standard SNMP notifications Keyword authentication coldstart linkdown linkup warmstart Definition Authentication failure notification sent when an NMS fails to authenticate to the SNMP agent. Notification sent when the device restarts. Notification sent when the link of a port goes down. Notification sent when the link of a port comes up. Notification sent when the SNMP agent restarts. system: Specifies notifications sent when the system time is modified, the system reboots, or the main system software image is not available. Usage guidelines The snmp-agent trap enable command enables the device to generate notifications, including both informs and traps, even though the keyword trap is used in the command. You can use the snmp-agent target-host command to enable the device to send the notifications as informs or traps to a host. If no optional parameters are specified, the command or its undo form enables or disables all SNMP notifications supported by the device. Examples # Enable the SNMP agent to send SNMP authentication failure traps to 10.1.1.1 in the community public. system-view [Sysname] snmp-agent target-host trap address udp-domain 10.1.1.1 params securityname public [Sysname] snmp-agent trap enable standard authentication 107