HP 6125XLG R2306-HP 6125XLG Blade Switch Network Management and Monitoring Con - Page 41
Configuration procedure, Con Switch B
View all HP 6125XLG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
Figure 12 Network diagram Configuration procedure 1. Set the IP address for each interface as shown in Figure 12. (Details not shown.) 2. Configure Switch C: # Enable the NTP service. system-view [SwitchC] ntp-service enable # Specify the local clock as the reference source, with the stratum level 2. [SwitchC] ntp-service refclock-master 2 # Configure Switch C to operate in broadcast server mode and send broadcast messages through VLAN-interface 2. [SwitchC] interface vlan-interface 2 [SwitchC-Vlan-interface2] ntp-service broadcast-server 3. Configure Switch A: # Enable the NTP service. system-view [SwitchA] ntp-service enable # Configure Switch A to operate in broadcast client mode and receive broadcast messages on VLAN-interface 2. [SwitchA] interface vlan-interface 2 [SwitchA-Vlan-interface2] ntp-service broadcast-client 4. Configure Switch B: # Enable the NTP service. system-view [SwitchB] ntp-service enable # Configure Switch B to operate in broadcast client mode and receive broadcast messages on VLAN-interface 2. [SwitchB] interface vlan-interface 2 [SwitchB-Vlan-interface2] ntp-service broadcast-client 5. Verify the configuration: 35