HP OmniBook xt6200 HP Omnibook xt6200 & vt6200 Notebook PCs - Corporate Ev - Page 170
Command, Function Ambit
View all HP OmniBook xt6200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 170 highlights
Reference Information Modem Reference Information Command I12 L0 L1 L2 L3 M0 M1 M2 M3 N0 N1 O0 O1 O2 P Q0 Q1 Sn Sn? Sn=v T V0 V1 W0 W1 W2 X0 X1 X2 X3 X4 Y0 Y1 Z0 Z1 &C0 &C1 &D0 &D1 &D2 &F0 &F1 &J0 &K0 Function (Ambit) Report driver time stamp Set low speaker volume Set low speaker volume Set medium speaker volume Set high speaker volume Turn speaker off Turn speaker on during handshaking and turn speaker off while receiving carrier Turn speaker on during handshaking and while receiving carrier Turn speaker off during dialing and receiving carrier and turn speaker on during answering Turn off automode detection Turn on automode detection Go on-line Go on-line and initiate a long retrain sequence Go on-line and initiate a short retrain sequence Force pulse dialing Allow result codes to DTE Inhibit result codes to DTE Select S-Register n as default Return the value of S-Register n Set default S-Register n to value v Force DTMF dialing Report short form result codes Report long form result codes Report DTE speed only Report line speed, EC protocol and DTE speed Report DCE speed only Report basic call progress result codes, i.e., Ok, Connect, Ring, No Carrier (also, for busy, if enabled, and dial tone not detected), No Answer and Error Report basic call progress result codes and connections speeds (Ok, Connect, Ring, No Carrier (also, for busy, if enabled, and dial tone not detected), No Answer, Connect XXXX, and Error Report basic call progress result codes and connections speeds, i.e., Ok, Connect, Ring, No Carrier (also, for busy, if enabled, and dial tone not detected), No Answer, Connect XXXX, and Error Report basic call progress result codes and connections rate, i.e., Ok, Connect, Ring, No Carrier, No Answer, Connect XXXX, Busy, and Error Report all call progress result codes and connections rate, i.e., Ok, Connect, Ring, No Carrier, No Answer, Connect XXXX, Busy, No Dial Tone and Error Report OK Report OK Restore stored profile 0 after warm reset Soft reset and restore stored profile 1 after warm reset Soft reset and force RLSD active regardless of the carrier state Allow RLSD to follow the carrier state Modem ignores DTR Modem enters command mode at DTR drop Modem hangs up at DTR drop Restore factory configuration 0 Restore factory configuration 1 Set S-Register response only for compatibility Disable DTE/DCE flow control 170 Corporate Evaluator's Guide