HP Workstation xw3100 HP Workstation xw3100 - Service and Technical Reference - Page 73
Drives, 5.10.1 Extra Screws, 5.10.2 Drive Positions
View all HP Workstation xw3100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 73 highlights
Removal and Replacement Procedures 5.10 Drives The workstation supports up to three drives. This Section describes the procedure for replacing or upgrading the storage drives. A Torx T-15 screwdriver is needed to remove and install the guide screws on a drive. Ä CAUTION: Make sure personal files on the hard drive are backed up to an external storage device before removing the hard drive. Failure to do so will result in data loss. After replacing the primary hard drive, you will need to run the Restore Plus! CD to load the Compaq factory-installed files. 5.10.1 Extra Screws The following spare guide screws are included with the chassis (located inside) for installing new drives: ■ Four 6-32 screws for installing an extra hard drive ■ Four M3 screws for installing an optical or diskette drive 5.10.2 Drive Positions Service and Technical Reference Guide, xw3100 338611-001 5-15