HP Workstation xw3100 HP Workstation xw3100 - Service and Technical Reference - Page 88
Speaker, Sound power level, LWAd B
View all HP Workstation xw3100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 88 highlights
Removal and Replacement Procedures 5.16 Speaker Sound power level Operation: Stand-by/Idle: Sound pressure level Operation: Stand-by/Idle: Hard Drive/48X CD-ROM Hard Drive/48X CD-ROM LWAd (B) 4.2/5.4 Bels 3.9 Bels dB 29/44 dBA 26 dBA To install the speaker: 1. Prepare the workstation for disassembly (Section 5.1). 2. Remove the workstation access panel (Section 5.5). 3. Rotate the drive cage to its upright position. 4. Remove the expansion card cage (Section 5.9). 5. Disconnect the speaker wire from the system board. 6. Carefully cut the cable tie that secures the speaker cable to the power supply cable bundle. Ä CAUTION: Be careful when cutting the cable tie not to cut any cables. 7. Remove the power supply from the chassis (Section 5.17). 8. Remove the two screws that secure the speaker to the chassis. 9. Slide the speaker towards the rear of the chassis and down to remove it. To install the speaker, reverse the removal procedures. 5-30 338611-001 Service and Technical Reference Guide, xw3100