HP Workstation xw3100 HP Workstation xw3100 - Service and Technical Reference - Page 97
Appendix B: Power Cord Set Requirements, General Requirements
View all HP Workstation xw3100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 97 highlights
B Power Cord Set Requirements The voltage select switch feature on the workstation permits it to operate from any line voltage between 100-120 or 220-240 volts AC. The power cord set received with the workstation meets the requirements for use in the country where you purchased the equipment. Power cord sets for use in other countries must meet the requirements of the country where you use the workstation. For more information on power cord set requirements, contact your authorized HP dealer, reseller, or service provider. General Requirements The requirements listed below are applicable to all countries: 1. The length of the power cord set must be at least 6.00 feet (1.8 m) and a maximum of 9.75 feet (3.0 m). 2. All power cord sets must be approved by an acceptable accredited agency responsible for evaluation in the country where the power cord set will be used. 3. The power cord set must have a minimum current capacity of 10A and a nominal voltage rating of 125 or 250 volts AC, as required by each country's power system. 4. The appliance coupler must meet the mechanical configuration of an EN 60 320/IEC 320 Standard Sheet C13 connector, for mating with appliance inlet on the Switch Box. Service and Technical Reference Guide, xw3100 B-1