HP rp5800 Maintenance & Service Guide HP rp5800 Retail System - Page 116
°C rear expansion slot cover vents, 50°C front bezel, 50°C heat sink, Expansion Cards,
View all HP rp5800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 116 highlights
50°C rear expansion slot cover vents Using the computer in 50°C mode requires that you install two half-height and two full-height expansion slot cover vents on the rear of the unit. To install these vent covers, follow the procedures in Expansion Cards on page 54 regarding removing and installing slot covers. The following image illustrates the rear of the computer with vent covers installed. Figure 7-72 Installing expansion slot cover vents 50°C front bezel Using the computer in 50°C mode requires that you install the correct front bezel that does not include an optical drive. To install the bezel, see Front Bezel on page 43. The following image illustrates the front of the computer with the 50°C bezel installed. Figure 7-73 50°C bezel configuration 50°C heat sink Using the computer in 50°C mode requires that you install a copper-based heat sink. Shape and installation procedure is the same as the standard, aluminum-based heat sink. To install the heat sink, see Heat sink on page 91. The following image illustrates the 50°C heat sink. 106 Chapter 7 Removal and Replacement Procedures