HP rp5800 Maintenance & Service Guide HP rp5800 Retail System - Page 76
Installing the Powered Serial Port Expansion Card in the Riser Card
View all HP rp5800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 76 highlights
6. Install the Powered Serial Port expansion card into the bottom socket on the riser card. Move the card toward the rear of the chassis so that the bracket on the card is aligned with the open slot on the rear of the chassis (1). Press the card straight down into the expansion socket on the riser card (2). NOTE: The Powered Serial Port expansion card must be installed in the bottom socket on the riser card. The bottom socket is designed specifically for that card. DO NOT attempt to install any other card in the bottom socket. Figure 7-24 Installing the Powered Serial Port Expansion Card in the Riser Card 7. Close the expansion card retention latch. Figure 7-25 Closing the Expansion Card Retention Latch 8. Rotate the power supply back down to its normal position. 9. Reassemble and reconfigure the computer, if necessary. 66 Chapter 7 Removal and Replacement Procedures