HP rp5800 Maintenance & Service Guide HP rp5800 Retail System - Page 90
Installing a 3.5-inch Secondary Hard Drive into a Drive Bay, CAUTION,
View all HP rp5800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 90 highlights
Installing a 3.5-inch Secondary Hard Drive into a Drive Bay The 3.5-inch secondary hard drive bay is located underneath the 5.25-inch optical drive. To install a secondary hard drive: 1. Follow the procedure in Removing a 5.25-inch Optical Drive from a Drive Bay on page 76 to remove the 5.25-inch optical drive and access the 3.5-inch secondary hard drive bay. CAUTION: Ensure that the computer is turned off and that the power cord is disconnected from the electrical outlet before proceeding. 2. Install four 6-32 standard guide screws in the holes on each side of the drive. HP has provided four extra 6-32 standard guide screws on the front of the chassis, under the front bezel. The 6-32 standard guide screws are silver. Refer to Installing and Removing Drives on page 74 for an illustration of the extra 6-32 standard guide screws location. NOTE: When replacing the drive, transfer the four 6-32 standard guide screws from the old drive to the new one. Figure 7-42 Installing Secondary Hard Drive Guide Screws 3. Position the guide screws on the drive into the J-slots in the drive bay. Then slide the drive toward the front of the computer until it locks into place. Figure 7-43 Installing a Secondary Hard Drive 80 Chapter 7 Removal and Replacement Procedures