Linksys WIP310 SPA500 Series and WIP310 IP Phone Administration Guide - Page 173

Configuring Regional Parameters and Supplementary Services Localizing Your IP Phone 7 To get better detection by the IVR, avoid inband and use OOB. This way, the DTMF tone is reconstructed by the PSTN gateway or the remote endpoint, and the quality is not subject to distortion from the audio codec. If you use OOB, use a slightly longer DTMF Playback Length. If you use inband, use a higher Inband DTMF boost. Localizing Your IP Phone The following table describes the localization parameters in the Miscellaneous section. Field Set Local Date (mm/dd) Set Local Time (HH/mm) Time Zone Time Offset (HH/ mm) Daylight Saving Time Rule Daylight Saving Enable Dictionary Server Script Description Enter the local date (mm represents the month and dd represents the day). The year is optional and uses two or four digits. For example, May 1, 2008, can be entered as: 05/01 or 05/01/08 or 05/01/2008 Enter the local time (hh represents hours and mm represents minutes). Seconds are optional. Selects the number of hours to add to GMT to generate the local time for caller ID generation. Choices are GMT-12:00, GMT11:00,..., GMT, GMT+01:00, GMT+02:00, ..., GMT+13:00. Defaults to GMT-08:00. This specifies the offset from GMT to use for the local system time. Enter the rule for calculating daylight saving time. See the "Configuring Daylight Savings Time" section on page 164. Select yes to enable or no to disable DST on the phone. This setting affects all lines (extensions) on the phone. Defines the location of the dictionary server, the languages available and the associated dictionary. See the "Creating a Dictionary Server Script" section on page 167. Cisco SPA 500 Series and WIP310 IP Phone Administration Guide 162