Linksys WIP310 SPA500 Series and WIP310 IP Phone Administration Guide - Page 198

Configuring the Cisco SPA 500S Attendant Console Setting Up the Cisco SPA 500S Attendant Console 9 NOTE Unit/key LEDs will not light without the "sub" keyword. (Not required for speed dials.) • usr or ext (optional)-Use one of these keywords to identify the specific users or extensions to be monitored. Its value and syntax is extensionNumber@$PROXY, where system variable $PROXY contains the proxy server IP and port (e.g. 192.168.8.101:6060). (The usr and ext keywords are interchangeable.) If the ext parameter is not used, all extensions on the phone are monitored. • nme (optional)- Use this field with the Cisco SPA 9000 to identify any alias that has been assigned to the extension in the IP phone configuration.The nme parameter indicates the extension name, which in this case is the same as the station name. • vid (optional)- All LEDs on the Cisco SPA 500S use phone extensions that they are assigned to. By default, LEDs on the Cisco SPA 500S are assigned to the first configured extension on the connected phone. You can optionally assign LEDs to any other phone extensions using vid=keyword. Use this field to identify the phone extension to use with the monitored list specified by the sub= keyword, when more than one BLF monitored list is configured on the SIP proxy server. The possible values are 1 to 6, corresponding to each of the six extensions available on the phone. Only use the vid= keyword in the first entry assigned to each phone extension. Subsequent keys will use the same extension. See "Attendant Console Parameters" section on page 190. Cisco SPA 500 Series and WIP310 IP Phone Administration Guide 187