Linksys WIP310 SPA500 Series and WIP310 IP Phone Administration Guide - Page 267

Cisco SPA 500 Series and Wireless IP Phone Field Reference Phone Tab B Parameter Description Speakerphone Input Gain The amount of amplification to apply to the audio input signal for the speakerphone. Defaults to zero. Handset Additional Input Gain Applies additional input gain to the handset. Headset Additional Input Gain Applies additional input gain to the headset. Speakerphone Additional Input Gain Applies additional input gain to the speakerphone. Multiple Paging Group Parameters Parameter Group Paging Script Description You can configure a phone as part of a paging group. Users can then direct pages to specific groups of phones. A phone can be part of no more than two paging groups, and user can page a maximum of five paging groups. The syntax is as follows: pggrp=ip-address:port;[name=xxx;]num=xxx; [listen={yes|no}]]; Where: IP address: Multicast IP address of the phone that will listen for and receive pages. port: Port on which to page; you must use different ports for each paging group. name (optional): The name of the paging group. num: The number users will dial to access the paging group; must be unique to the group. listen: If the phone should listen on the page group. Only the first two groups with listen set to yes will listen to group pages. If the field is not defined, the default value is no, so you must set this field to listen to the group pages. Cisco SPA 500 Series and WIP310 IP Phone Administration Guide 256