Linksys WIP310 SPA500 Series and WIP310 IP Phone Administration Guide - Page 29

Getting Started Using IVR on the Cisco SPA 501G IP Phone 1 Number 221 73738 87778 732668 111 121 131 161 Option Set call control-enter the value for the call control method you want, then press #: • 0: SIP • 1: SPCP To save, press 1; to review, press 2; to re-enter, press 3; to exit, press *. Restore the phone to the factory default software and settings. Enter 1 to confirm, or * to exit. If you chose to reset, hang up to exit and begin the restore process. Restore the phone's user settings to the default. (Clears all user settings such as speed dials.) Enter 1 to confirm, or * to exit. If you chose to reset, hang up to exit and begin the restore process. Reboot the phone. After entering #, hang up to begin rebooting. Set a static IP address. Enter the address (use * to enter the "." value), then press #. To save, press 1; to review, press 2; to re-enter, press 3; to exit, press *. NOTE DHCP must be disabled to use this option; if DHCP is not disabled, you receive an error message. Set a netmask. Enter the address (use * to enter the "." value), then press #. To save, press 1; to review, press 2; to re-enter, press 3; to exit, press *. NOTE DHCP must be disabled to use this option; if DHCP is not disabled, you receive an error message. Set a gateway. Enter the address (use * to enter the "." value), then press #. To save, press 1; to review, press 2; to re-enter, press 3; to exit, press *. NOTE DHCP must be disabled to use this option; if DHCP is not disabled, you receive an error message. Set the address of the primary Domain Name Server (DNS). Enter the address (use * to enter the "." value), then press #. To save, press 1; to review, press 2; to re-enter, press 3; to exit, press *. Cisco SPA 500 Series and WIP310 IP Phone Administration Guide 18