Oki MB471 Quick Start Guide - Page 31
Connecting as an Internal Telephone, Step 3 Configuring Basic Settings
View all Oki MB471 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
Faxing (For MB451, MB451w, MB471, MB471w, MB491, MB491+, MB491+LP, ES4191 MFP, MPS4200mb, MPS4700mb only) Connecting as an Internal Telephone Note ●● Do not connect with USB cable or LAN cable at this point. First, check that the machine is turned off. If the machine is turned on, hold down the power switch for approximately one second to turn off the power. Plug the [Telephone cable] connected to a control device including PBX, etc. into the [LINE connection] of your machine. LINE connection Public Line (Analog) Control device including PBX, etc. Te l e p h o n e cable Memo ●● Set [PBX Line] to [ON]. Refer to "Step 3-4 PBX Connecting" P.35 in detail. Initial Setup for Faxing Step 3 Configuring Basic Settings This section explains how to configure the basic settings on the machine for the fax function. Follow the 6 sub steps below: ●● "Step 3-1 Settings for Each Dialing Type" P.31 ●● "Step 3-2 Setup of Date/Time" P.32 3 ●● "Step 3-3 Specifying Sender Information" P.33 ●● "Step 3-4 PBX Connecting" P.35 ●● "Step 3-5 Setting for Super G3" P.36 ●● "Step 3-6 Specifying Reception Mode" P.37 Note ●● You need to complete the country code setting and connect the telephone line according to your environment before this procedure. Memo ●● You can skip step 3-4 and 3-5 depending on your environment. For details, refer to each description. Step 3-1 Settings for Each Dialing Type Specify the dialing type for transmission according to your environment. The factory default for [MF(Tone)/DP(Pulse)] is set to [Tone]. ●● For push-button phones, if you hear a "Beep, boop, beep" sound, leave [MF(Tone)/ DP(Pulse)] as [Tone]. ●● For push-button type phones, if you do not hear a "Beep, boop, beep" sound, set [MF(Tone)/DP(Pulse)] to [Pulse]. ●● For rotary-dial type phones, set [MF(Tone)/ DP(Pulse)] to [Pulse]. 1 Press the key on the operator panel. - 31 -