D-Link DGS-3308FG Product Manual - Page 104

8-port Gigabit Ethernet Switch User's Guide • Interface Name:[ ] - Enter the name of the IP interface that is to be configured for multicasting in this field. This must be a previously configured IP interface. See Setting up IP Interfaces in Chapter 6 of this manual for more information. • IGMP: < > - Toggle between Enabled and Disabled using the space bar. This will enable or disable IGMP for the IP interface entered above. • Protocol: < > - Toggle among PIM-DM (Protocol Independent Multicasting - Dense Mode), DVMRP (Distance Vector Multicasting Routing Protocol), and INACT (inactive). INACT is not a multicast routing protocol. It is used to make a given interface inactive for IP routing. IGMP Interface Configuration To configure the IGMP interface, highlight IGMP Interface Configuration from the IP Multicasting Settings menu and press Enter. Figure 6-42. IGMP Interface Configuration screen • Interface Name:[ defined. ] - Enter the name of the interface in this field. This interface must be previously • Querier State:< > - This field can be toggled between V1-Querier and V2-Querier. This is the version of IGMP that the interface will use (IGMP version 1 or IGMP version 2). • Query:[ ] - This field allows an entry between 1 and 65,500 seconds and defines the time between transmitting IGMP queries. • Max Response:[ ] - This field allows an entry between 1 and 25 and defines the maximum time allowed before sending a response report to a query measured in units of 1/10 of a second. This is used to adjust the "leave latency", the time internal between the moment the last host leaves a group and when the routing protocol is notified there are no more members. 94