D-Link DGS-3308FG Product Manual - Page 70

8-port Gigabit Ethernet Switch User's Guide Configuration Yes Network Monitoring Yes Community Strings and Trap Stations Yes Update Firmware and Configuration Yes Files System Utilities Yes Factory Reset Yes Reboot Switch Yes User Accounts Management Read Only Read Only Read Only No Ping Only No Yes Read Only Read Only Read Only No Ping Only No No Add/Update/Delete User Accounts Yes No No View User Accounts Yes No No Table 6-1. Root, User+, and User Privileges After establishing a User Account with Root-level privileges, press Esc. Then highlight Save Changes and press Enter (see below). The Switch will save any changes to its non-volatile ram and reboot. You can logon again and are now ready to continue configuring the Switch. Save Changes The DGS-3308 has two levels of memory; normal RAM and non-volatile or NV-RAM. Configuration changes are made effective by highlighting Apply and pressing Enter. When this is done, the settings will be immediately applied to the switching software in RAM, and will immediately take effect. Some settings, though, require you to restart the switch before they will take effect. Restarting the Switch erases all settings in RAM and reloads the stored settings from the NV-RAM. Thus, it is necessary to save all setting changes to NV-RAM before rebooting the Switch. To retain any configuration changes permanently, highlight Save Changes from the Main Menu. The following screen will appear to verify that your new settings have been saved to NV-RAM: 60