Dell PowerEdge XL 5133-4 MXL 10/40GbE Switch IO Module FTOS Command Reference - Page 138
command from EXEC Privilege mode., To display the routing table for a given port, use
View all Dell PowerEdge XL 5133-4 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 138 highlights
www.dell.com | support.dell.com To display the configuration for a given port, use the show interface command from EXEC Privilege mode (Figure 10-5). To display the routing table for a given port, use the show ip route command from EXEC Privilege mode. Figure 10-5. Viewing Management Routes FTOS#show interface tengigabit 0/46 TenGigabitEthernet 0/4 is up, line protocol is up Port is part of Port-channel 1 Hardware is DellForce10Eth, address is 00:01:e8:e1:e1:c1 Current address is 00:01:e8:e1:e1:c1 Server Port AdminState is Up Pluggable media not present Interface index is 34935553 Internet address is not set Mode of IP Address Assignment : NONE DHCP Client-ID :tenG1330001e8e1e1c1 MTU 12000 bytes, IP MTU 11982 bytes LineSpeed 10000 Mbit Flowcontrol rx off tx off ARP type: ARPA, ARP Timeout 04:00:00 Last clearing of "show interface" counters 00:10:18 Queueing strategy: fifo Input Statistics: 202 packets, 24015 bytes 103 64-byte pkts, 20 over 64-byte pkts, 52 over 127-byte pkts 27 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts 163 Multicasts, 39 Broadcasts 0 runts, 0 giants, 0 throttles 0 CRC, 0 overrun, 0 discarded Output Statistics: 356 packets, 80597 bytes, 0 underruns 36 64-byte pkts, 34 over 64-byte pkts, 44 over 127-byte pkts 242 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts 271 Multicasts, 85 Broadcasts, 0 Unicasts 0 throttles, 0 discarded, 0 collisions, 0 wreddrops Rate info (interval 299 seconds): Input 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate Output 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate Time since last interface status change: 00:10:23 FTOS# 124 | Interfaces