Dell PowerEdge XL 5133-4 MXL 10/40GbE Switch IO Module FTOS Command Reference - Page 252
Command Output, show interfaces, show running-config uplink-state-group
View all Dell PowerEdge XL 5133-4 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 252 highlights
www.dell.com | support.dell.com Figure 20-4. show interfaces Command Output FTOS#show interfaces tengigabitethernet 0/5 TenGigabitEthernet 0/5 is up, line protocol is down(error-disabled[UFD]) Hardware is DellForce10Eth, address is 00:1e:c9:f1:04:80 Current address is 00:1e:c9:f1:04:80 Server Port AdminState is N/A Pluggable media not present Interface index is 35197697 Internet address is not set Mode of IP Address Assignment : NONE DHCP Client-ID :tenG134001ec9f10480 MTU 12000 bytes, IP MTU 11982 bytes LineSpeed auto Flowcontrol rx on tx off ARP type: ARPA, ARP Timeout 04:00:00 Last clearing of "show interface" counters 00:28:09 Queueing strategy: fifo Input Statistics: 0 packets, 0 bytes 0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts 0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts 0 Multicasts, 0 Broadcasts 0 runts, 0 giants, 0 throttles 0 CRC, 0 overrun, 0 discarded Output Statistics: 0 packets, 0 bytes, 0 underruns 0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts 0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts 0 Multicasts, 0 Broadcasts, 0 Unicasts 0 throttles, 0 discarded, 0 collisions, 0 wreddrops Rate info (interval 299 seconds): Input 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate Output 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate Time since last interface status change: 00:25:03 Figure 20-5. show running-config uplink-state-group Command: UFD Output FTOS# show running-config uplink-state-group ! uplink-state-group 1 downstream TenGigabitEthernet 0/1-32 downstream TenGigabitEthernet 1/1-32 upstream Port-channel 128 defer-timer 10 238 | Uplink Failure Detection (UFD)