Dell PowerEdge XL 5133-4 MXL 10/40GbE Switch IO Module FTOS Command Reference - Page 159
Viewing Interface Information, Displaying Non-Default Configurations,
View all Dell PowerEdge XL 5133-4 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 159 highlights
Figure 10-21 shows the auto-negotiation options. Figure 10-21. Setting Auto-Negotiation Options FTOS(conf)# int tengig 0/0 FTOS(conf-if)#neg auto FTOS(conf-if-autoneg)# ? end Exit from configuration mode exit Exit from autoneg configuration mode mode Specify autoneg mode no Negate a command or set its defaults show Show autoneg configuration information FTOS(conf-if-autoneg)#mode ? forced-master Force port to master mode forced-slave Force port to slave mode FTOS(conf-if-autoneg)# Viewing Interface Information Displaying Non-Default Configurations The show [ip | running-config] interfaces configured command allows you to display only interfaces that have non-default configurations are displayed. Figure 10-22 shows the possible show commands that have the configured keyword available. Figure 10-22. show Commands with configured Keyword Examples FTOS#show interfaces configured FTOS#show interfaces tengigabitEthernet 0 configured FTOS#show ip interface configured FTOS#show ip interface tengigabitEthernet 1 configured FTOS#show ip interface brief configured FTOS#show running-config interfaces configured FTOS#show running-config interface tengigabitEthernet 1 configured Interfaces | 145