Dell PowerEdge XL 5133-4 MXL 10/40GbE Switch IO Module FTOS Command Reference - Page 250
Displaying Uplink Failure Detection
View all Dell PowerEdge XL 5133-4 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 250 highlights
www.dell.com | support.dell.com Displaying Uplink Failure Detection To display information on the Uplink Failure Detection feature, enter any of the following show commands: Show Command Syntax Description show uplink-state-group [group-id] [detail] Command Mode: EXEC Displays status information on a specified uplink-state group or all groups. Valid group-id values are 1 to 16. detail displays additional status information on the upstream and downstream interfaces in each group (see Figure 20-3). show interfaces interface Command Mode: EXEC Displays the current status of a port or port-channel interface assigned to an uplink-state group. interface specifies one of the following interface types: 10-Gigabit Ethernet: Enter tengigabitethernet slot/port. 40-Gigabit Ethernet: Enter fortygigabitethernet slot/port. Port channel: Enter port-channel {1-512}. If a downstream interface in an uplink-state group has been disabled (Oper Down state) by uplink-state tracking because an upstream port went down, the message error-disabled[UFD] is displayed in the output (see Figure 20-4). show running-config uplink-state-group [group-id] Command Mode: EXEC Or show configuration Command Mode: UPLINK-STATE-GROUP Displays the current configuration of all uplink-state groups (Figure 20-5) or a specified group. Valid group-id values are 1 to 16. 236 | Uplink Failure Detection (UFD)