Dell PowerEdge XL 5133-4 MXL 10/40GbE Switch IO Module FTOS Command Reference - Page 237
Broadcast Storm Control, Displaying Broadcast-Storm Control Status
View all Dell PowerEdge XL 5133-4 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 237 highlights
18 Broadcast Storm Control On the Aggregator, the broadcast storm control feature is enabled by default on all ports, and disabled on a port when an iSCSI storage device is detected. Broadcast storm control is re-enabled as soon as the connection with an iSCSI device ends. Broadcast traffic on Layer 2 and Layer 3 interfaces is limited or suppressed during a broadcast storm. You can view the status of a broadcast-storm control operation by using the show io-aggregator broadcast storm-control status command. You can disable broadcast storm control by using the no io-aggregator broadcast storm-control command. FTOS Behavior: If broadcast traffic exceeds 1000 Mbps, the Aggregator limits it to 1000 Mbps per port-pipe. Displaying Broadcast-Storm Control Status To display the status of a current storm control operation, enter the following command: Task Command Display status (enabled/disabled) of broadcast storm show io-aggregator broadcast control and the traffic limit applied. storm-control status Command Mode EXEC Privilege Disabling Broadcast Storm Control To disable broadcast storm control on an Aggregator, enter the following command: Task Disable broadcast storm control. Command no io-aggregator broadcast storm-control Command Mode CONFIGURATION To re-enable broadcast storm control, enter the io-aggregator broadcast storm-control command. Broadcast Storm Control | 223