Dell PowerEdge XL 5133-4 MXL 10/40GbE Switch IO Module FTOS Command Reference - Page 36
Console access, Serial Console
View all Dell PowerEdge XL 5133-4 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
www.dell.com | support.dell.com Figure 4-2. Port Numbering on an Aggregator 2-Port 40-GbE QSFP+ FlexIO Module (4x10GbE mode): Ports 53 to 56 (top port) Ports 49 to 52 (bottom port) 2-Port 40-GbE QSFP+ FlexIO Module (4x10GbE mode): Ports 45 to 48 (top port) Ports 41 to 44(bottom port) 4-Port 10-GbE SFP+ or 4-Port 10GBASE-T FlexIO Module: Ports 49 to 52 (4x10GbE mode) 4-Port 10-GbE SFP+ or 4-Port 10GBASE-T FlexIO Module: Ports 41 to 44 (4x10GbE mode) 40GbE QSFP+ Port 37 (stacking) or Ports 37 to 40 (4x10GbE mode) 40GbE QSFP+ Port 33 (stacking) or Ports 33 to 36 (4x10GbE mode) Console access The Aggregator has two management ports available for system access: a serial console port and an out-of-bounds (OOB) port. Serial Console A universal serial bus (USB) (A-Type) connector is located on the front panel. The USB can be defined as an External Serial Console (RS-232) port, and is labeled on the Aggregator. The USB is on the lower side of an installed Aggregator, as you face the I/O side of the M1000e chassis (Figure 4-1). For the console port piMnout, refer to Table 4-1. To access the console port, follow these steps. Step 1 2 Task Connect the USB connector to the front panel. Use the RS-232 Serial Line cable to connect the Aggregator console port to a terminal server. Connect the other end of the cable to the DTE terminal server. 22 | Getting Started