Dell PowerEdge XL 5133-4 MXL 10/40GbE Switch IO Module FTOS Command Reference - Page 25

Navigating CLI Modes The FTOS prompt changes to indicate the CLI mode. Table 3-1 lists the CLI mode, its prompt, and information about how to access and exit this CLI mode. You must move linearly through the command modes, with the exception of the end command, which takes you directly to EXEC Privilege mode and the exit command moves you up one command mode level. Note: Sub-CONFIGURATION modes all have the letters "conf" in the prompt with additional modifiers to identify the mode and slot/port information. These are shown in Table 3-1. Table 3-1. FTOS Command Modes CLI Command Mode EXEC EXEC Privilege CONFIGURATION Prompt FTOS> FTOS# FTOS(conf)# Access Command Access the router through the console or Telnet. • From EXEC mode, enter the command enable. • From any other mode, enter the command end. • From EXEC privilege mode, enter the command configure. • From every mode except EXEC and EXEC Privilege, enter the command exit. Note: Access the following modes from CONFIGURATION mode: 10 Gigabit Ethernet Interface FTOS(conf-if-te-0/1)# interface INTERFACE modes LINE Interface Range Management Ethernet Interface Monitor Session IP COMMUNITY-LIST FTOS(conf-if-range)# FTOS(conf-if-ma-0/0)# FTOS(conf-mon-sess) FTOS(conf-community-list)# interface interface monitor session ip community-list CONSOLE FTOS(conf-line-console)# line VIRTUAL TERMINAL FTOS(conf-line-vty)# line Configuration Fundamentals | 11