Dell PowerEdge XL 5133-4 MXL 10/40GbE Switch IO Module FTOS Command Reference - Page 55

Changing System Logging Settings You can change the default settings of the system logging by changing the severity level and the storage location. The default is to log all messages up to debug level, that is, all system messages. By changing the severity level in the logging commands, you control the number of system messages logged. To change the severity level of messages logged to a syslog server, use any or all of the following commands in CONFIGURATION mode: Task Specify the minimum severity level for logging to the logging buffer. Specify the minimum severity level for logging to the console. Specify the minimum severity level for logging to terminal lines. Specifying the minimum severity level for logging to a syslog server. Specify the minimum severity level for logging to the syslog history table. Command Syntax logging buffered level logging console level logging monitor level logging trap level logging history level Command Mode CONFIGURATION CONFIGURATION CONFIGURATION CONFIGURATION CONFIGURATION Task Specify the size of the logging buffer. Note: When you decrease the buffer size, FTOS deletes all messages stored in the buffer. Increasing the buffer size does not affect messages in the buffer. Specify the number of messages that FTOS saves to its logging history table. Command Syntax logging buffered size logging history size size Command Mode CONFIGURATION CONFIGURATION To view the logging buffer and configuration, enter the show logging command in EXEC privilege mode (Figure 5-1). To view the logging configuration, enter the show running-config logging command in EXEC privilege mode (Figure 5-2). Aggregator Management | 41