HP 6125G HP 6125G & 6125G/XG Blade Switches High Availability Command - Page 85
preemption delay
View all HP 6125G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 85 highlights
master: Specifies the port as the master port. slave: Specifies the port as the slave port. Description Use port smart-link group to configure the current port as a member of the specified smart link group. Use undo port smart-link group to remove the port from the specified smart link group. Disable the spanning tree feature and RRPP on the ports you want to add to the smart link group, and make sure the ports are not member ports of any aggregation group or service loopback group. On the other hand, you cannot enable the spanning tree feature or RRPP on a smart link group member port or assign a smart link group member port to an aggregation group or service loopback group. You can assign a port to a smart link group with the port command in smart link group view. Related commands: port. Examples # Configure GigabitEthernet 1/0/1 as the master port of smart link group 1. system-view [Sysname] smart-link group 1 [Sysname-smlk-group1] protected-vlan reference-instance 0 [Sysname-smlk-group1] quit [Sysname] interface gigabitethernet 1/0/1 [Sysname-GigabitEthernet1/0/1] undo stp enable [Sysname-GigabitEthernet1/0/1] port smart-link group 1 master # Configure Layer 2 aggregate interface 1 as the master port of smart link group 1. system-view [Sysname] smart-link group 1 [Sysname-smlk-group1] protected-vlan reference-instance 0 [Sysname-smlk-group1] quit [Sysname] interface bridge-aggregation 1 [Sysname-Bridge-Aggregation1] undo stp enable [Sysname-Bridge-Aggregation1] port smart-link group 1 master preemption delay Syntax preemption delay delay-time View undo preemption delay Smart link group view Default level 2: System level Parameters delay-time: Preemption delay (in seconds), in the range of 0 to 300. 80