HP 6125G HP 6125G & 6125G/XG Blade Switches High Availability Command - Page 88
smart-link flush enable, to disable flush message processing.
View all HP 6125G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 88 highlights
View User view Default level 2: System level Parameters None Description Use reset smart-link statistics to clear flush message statistics. Examples # Clear flush message statistics. reset smart-link statistics smart-link flush enable Syntax smart-link flush enable [ control-vlan vlan-id-list ] undo smart-link flush enable [ control-vlan vlan-id-list ] View Layer 2 Ethernet interface view, Layer 2 aggregate interface view Default level 2: System level Parameters control-vlan vlan-id-list: Specifies the control VLANs used for receiving flush messages. The vlan-id-list is expressed in the form of vlan-id-list = { vlan-id [ to vlan-id ] }&, where the vlan-id argument represents the ID of a control VLAN and ranges from 1 to 4094. & indicates that you can provide up to ten VLAN IDs or VLAN ID lists. Description Use smart-link flush enable to configure a receive control VLAN-a VLAN for receiving flush messages. Use undo smart-link flush enable to disable flush message processing. By default, flush messages are not processed. If no VLAN is specified, VLAN 1 applies. Do not use this command on the member port of an aggregation group or service loopback group. Related commands: flush enable. Examples # Enable GigabitEthernet 1/0/1 to process the flush messages received in VLAN 1. system-view [Sysname] interface gigabitethernet 1/0/1 [Sysname-GigabitEthernet1/0/1] smart-link flush enable # Enable Layer 2 aggregate interface 1 to process the flush messages received in VLAN 1. system-view 83