IBM 436854u Service Guide - Page 104

Installing the simple-swap backplate This procedure applies only to server models with the simple-swap SATA backplate installed on the back of the hard disk drive cage. To install the simple-swap backplate, complete the following steps. 1. Position the bottom edge of the simple-swap backplate on the lower lip of the drive cage. Retaining tab Retaining latch Simple-swap backplate Locating pins Drive cage release tab 2. Tilt the top of the simple-swap backplate toward the drive cage and over the locating pins until the retaining latch is engaged securely. 3. Press and hold the retaining tab on top of the cage; then, rotate the drive cage into the chassis until it locks into place. 4. Connect the signal cables to the system board (see "System-board internal connectors" on page 9 for the location of the Serial ATA drive connectors). 5. Connect the power cables to the simple-swap backplate. 6. Install the hard disk drive fan assembly on the hard disk drive cage (see "Installing the hard disk drive fan assembly" on page 83). 7. Install the simple-swap hard disk drives that you removed from the hard disk drive cage (see "Installing a simple-swap hard disk drive" on page 71). 8. Install the lower bezel (see "Installing the lower bezel" on page 55). 9. Install the side cover (see "Installing the side cover" on page 53). 10. Lock the side cover if you unlocked it during removal. 11. Reconnect the external cables and power cords; then, turn on the attached devices and turn on the server. 86 System x3200 M2 Types 4367 and 4368: Problem Determination and Service Guide