IBM 436854u Service Guide - Page 77

9. If you are instructed to return the adapter, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you. Installing an adapter For information about the types of adapters that the server supports and other information that you might consider when you install an adapter, see the User's Guide. For the locations of the expansion slots and optional-device connectors see "System-board optional-devices connectors" on page 11. Notes: 1. If you are replacing a Remote Supervisor Adapter II SlimLine, it must be installed in its dedicated connector on the system board (see "System-board optional-devices connectors" on page 11). 2. When you start the server for the first time after you install a Remote Supervisor Adapter II SlimLine, the startup process will take several minutes longer than a typical startup. To install a replacement adapter, complete the following steps: 1. Check the instructions that come with the adapter for any requirements, restrictions, or cabling instructions. It might be easier to route cables before you install the adapter. 2. Follow the instructions that come with the adapter to set jumpers or switches, if any. 3. Touch the static-protective package that contains the adapter to any unpainted metal surface on the server. Then, remove the adapter from the static-protective package. Avoid touching the components and gold-edge connectors on the adapter. 4. If you are installing a full-length adapter, remove the blue adapter guide (if any) from the end of the adapter. Adapter guide 5. Carefully grasp the adapter by the top edge or upper corner, and move the adapter directly from the static-protective package to the expansion slot. Align the adapter with the expansion slot guides; then, press the adapter firmly into Chapter 4. Removing and replacing server components 59