IBM 436854u Service Guide - Page 89

Installing a simple-swap hard disk drive This procedure applies only to server models that have simple-swap SATA hard disk drives. See the User's Guide for information about the installation sequence and other important information. Attention: Simple-swap hard disk drives are not hot-swappable. Disconnect all power from the server you remove or install a simple-swap hard disk drive. To install a simple-swap hard disk drive, complete the following steps: 1. Touch the static-protective package that contains the drive to any unpainted metal surface on the server; then, remove the drive from the package and place it on a static-protective surface. 2. Align the drive assembly with the guide rails in the bay. 3. Pull the loops of the drive assembly toward each other; then, carefully slide the drive assembly into the drive bay until it stops, and release the loops. Note: Do not release the loops on the drive assembly until it is completely seated. 4. Install the lower bezel (see "Installing the lower bezel" on page 55). 5. Lock the side cover. 6. Reconnect the external cables and power cords; then, turn on the attached devices and turn on the server. Chapter 4. Removing and replacing server components 71