IBM 436854u Service Guide - Page 111

Installing the front adapter-retention bracket To install the front adapter-retention bracket, complete the following steps: 1. Insert one of the hinge pins on the front adapter-retention bracket into the metal hinge point on the fan cage assembly. 2. Rotate the other hinge pin on the front adapter-retention bracket into position and push the hinge pin into the other metal hinge point. The hinge pin will protrude through the hole in the metal hinge point when the adapter-retention bracket is seated correctly. 3. Reinstall any adapters that you removed earlier. 4. Close the front and rear adapter retention brackets. 5. Install the side cover (see "Installing the side cover" on page 53). 6. Lock the side cover. 7. Reconnect the external cables and power cords; then, turn on the attached devices and turn on the server. Installing the front USB connector assembly To install the front USB connector assembly, complete the following steps: 1. Carefully insert the front USB cable through the opening in the front of the chassis. 2. Squeeze the spring clips on the sides of the front USB connector assembly and insert the assembly into the housing through the back of the housing. 3. Place the bottom edge of the housing into the bottom of the opening in the chassis; then, tilt the top of the housing into position until it clicks into place. 4. Reroute and connect the front USB cable to the system board (see "System-board internal connectors" on page 9 for the location of the front USB connector). 5. Install the upper bezel (see "Installing the upper bezel" on page 57). 6. Install the lower bezel (see "Installing the lower bezel" on page 55). 7. Install the side cover (see "Installing the side cover" on page 53). 8. Lock the side cover if you unlocked it during removal. 9. Reconnect the external cables and power cords; then, turn on the attached devices and turn on the server. Chapter 4. Removing and replacing server components 93