IBM 436854u Service Guide - Page 21

Features and specifications The following information is a summary of the features and specifications of the server. Depending on the server model, some features might not be available, or some specifications might not apply. Table 1. Features and specifications Microprocessor: v Supports one Intel Core™ 2 Duo dual-core or Xeon dual-core or quad-core microprocessor Note: Intel Virtualization Technology (VT) is not available on the Core 2 Duo E4600; however, these microprocessors can only run paravirtualization. v 2 MB, 6 MB, or 12 MB Level-2 cache v 800, 1066, or 1333 MHz front-side bus (FSB) Memory: v Minimum: 512 MB v Maximum: 8 GB v Types: PC2-5300 or PC2-6400, ECC unbuffered double-data-rate 2 (DDR2) 667 or 800 MHz SDRAM v Connectors: four dual inline memory module (DIMM) connectors, two-way interleaved Drives (depending on the model): v Diskette (optional): External or internal USB FDD drive and memory key v Hard disk drive: Hot-swap SAS, hot-swap SATA, or simple-swap SATA v One of the following SATA attached optical drives: - DVD-ROM - Multiburner (optional) Drive bays (depending on the model): v Two 5.25 in. half-high bays (one optical drive installed) v One 3.5 in. slim-high removable-media drive bay (optional diskette drive) v Four 3.5 in. or 2.5 in. slim-high hard disk drive bays (some models) v Eight 2.5 in. slim-high hard disk drive bays (some models) PCI expansion slots (depending on the model): v One PCI Express x8 slot v One PCI Express x4 slot (x4 slot with x1 electrical) v One PCI-X 64-bit/133 MHz slot Note: This PCI-X slot is enabled when an optional PCI-X enablement card is installed in the mini-PCI slot on the system board. When no mini-PCI-X enablement card installed, this slot has no function. Fans: Three speed-controlled fans. Power supply: One of the following power supplies: v One or two redundant 430-watt (90-240 V ac) v One non-redundant 401-watt (90-240 V ac) Size: v Height: 438 mm (17.25 in.) v Depth: 540 mm (21.25 in.) v Width: 216 mm (8.5 in.) v Weight: 16.3 kg (36 lb) to 25.2 kg (56 lb) depending upon configuration Integrated functions: v Mini-baseboard management controller (mini-BMC) v Broadcom BCM5722 10/100/1000 Ethernet controller on the system board with RJ-45 Ethernet port v One internal single-channnel (four ports per channel) SAS/SATA controller (mini-PCI slot) v Two serial ports v One parallel port v Six-port Serial ATA controller v Eight Universal Serial Bus (USB) v2.0 ports (two on front and four on rear, one internal for optional tape drive, and one internal for optional Remote Supervisor Adapter II SlimLine) v Onboard ATI ES1000 video controller - Compatible with SVGA and VGA - 64 MB DDR2 SDRAM video memory Diagnostic LEDs: v Fans v Hard disk drives v Memory v Microprocessor v PCI slots v Power supply v VRD Acoustical noise emissions: v Sound power, idling: 5.0 bel v Sound power, operating: 5.3 bel Environment: v Air temperature: - Server on: 10° to 35°C (50° to 95°F) Altitude: 0 to 914.4 m (3000 ft) - Server on: 10° to 32°C (50° to 89.6°F) Altitude: 914.4 m (3000 ft) to 2133.6 m (7000 ft) - Server off: 10° to 43°C (50° to 109.4°F) Maximum altitude: 2133.6 m (7000 ft) - Shipping: -40° to 60°C (-40° to 140°F) v Humidity (operating and storage): - Server on: 8% to 80% - Server off: 8% to 80% Heat output: Approximate heat output in British thermal units (Btu) per hour: v Minimum configuration: 630 Btu per hour (185 watts) v Maximum configuration: 1784 Btu per hour (523 watts) Electrical input: v Sine-wave input (50 or 60 Hz) required v Input voltage and frequency ranges automatically selected v Input voltage low range: - Minimum: 100 V ac - Maximum: 127 V ac v Input voltage high range: - Minimum: 200 V ac - Maximum: 240 V ac v Input kilovolt-amperes (kVA) approximately: - Minimum: 0.20 kVA (all models) - Maximum: 0.55 kVA Notes: 1. Power consumption and heat output vary depending on the number and type of optional features that are installed and the power-management optional features that are in use. 2. These levels were measured in controlled acoustical environments according to the procedures specified by the American National Standards Institute (ANSI) S12.10 and ISO 7779 and are reported in accordance with ISO 9296. Actual sound-pressure levels in a given location might exceed the average stated values because of room reflections and other nearby noise sources. The declared sound-power levels indicate an upper limit, below which a large number of computers will operate. v Two PCI 32-bit/33 MHz slots Chapter 1. Introduction 3