IBM 436854u Service Guide - Page 115
Installing the SAS/SATA controller, Removing the optional mini-PCI-X enablement card
UPC - 883436026772
View all IBM 436854u manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 115 highlights
Installing the SAS/SATA controller To install the SAS/SATA RAID controller, complete the following steps: 1. Touch the static-protective package that contains the SAS/SATA controller to any unpainted surface on the outside of the server; then, remove the SAS/SATA controller from the package. 2. Position the SAS/SATA controller over the connector and the plastic standoff; then, press the SAS/SATA controller firmly into the connector and onto the plastic standoff. Alignment pins Mini-PCI controller slot Alignment holes Mini-SAS/SATA controller 3. Connect the signal cable to the SAS/SATA controller. 4. Install and lock the side cover (see "Installing the side cover" on page 53). 5. Reconnect the external cables and power cords; then, turn on the attached devices and turn on the server. Removing the optional mini-PCI-X enablement card To remove the mini-PCI-X enablement card, complete the following steps: 1. Read the safety information that begins on page vii and "Installation guidelines" on page 47. 2. Turn off the server and all attached devices; then, disconnect all power cords and external cables. 3. Unlock and remove the side cover (see "Removing the side cover" on page 52). 4. Open the rear adapter-retention bracket until the release lever on the right side of the bracket clicks into place. 5. Carefully disengage the tabs on each side of the mini-PCI slot connector and the front of the mini-PCI-X enablement card from the plastic standoff. Chapter 4. Removing and replacing server components 97