IBM 436854u Service Guide - Page 86
Installing a hot-swap hard disk drive
UPC - 883436026772
View all IBM 436854u manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 86 highlights
Server model with four hot-swap drive bays Server model with eight hot-swap drive bays Drive-tray assembly Drive-tray assembly Drive tray handle (in open position) Drive tray handle (in open position) Bezel 5. Grasp the handle of the drive assembly that is to be replaced and pull the assembly out of the bay. 6. If you are instructed to return the drive assembly, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you. Installing a hot-swap hard disk drive This procedure applies only to server models that have hot-swap hard disk drives. Before you install a hot-swap hard disk drive, read the following information: v The hot-swap drives must be either all SAS hard disk drives or all SATA hard disk drives; the two types cannot be combined. v Inspect the drive tray for signs of damage. v To maintain proper system cooling, do not operate the server for more than 10 minutes without either a drive or a filler panel installed in each drive bay. v You do not have to turn off the server to install hot-swap drives in the hot-swap drive bays. v See the User's Guide for additional information. To install a hot-swap hard disk drive (based on your model), complete the following steps. 68 System x3200 M2 Types 4367 and 4368: Problem Determination and Service Guide