Kyocera KM-8530 KM-8530 Operation Guide - Page 145

Troubleshooting Tips (continued) COPYING DOES NOT RESUME AFTER MISHANDLED PAPER IS REMOVED Check copier diagram on touch screen for additional indications of mishandled paper. COPY QUALITY IS POOR Check paper for dampness, and replace it if necessary. THE ORIGINAL PAPER IS MISHANDLED OR SKEWED IN THE DOCUMENT FEEDER Originals should conform to the recommended size and weight. Be sure originals are not stapled. Align originals evenly in the RADF. Check to make sure paper guides meet the width of mixed size originals. COPY IMAGE IS SKEWED WHEN BYPASS IS USED Be sure copy paper is inserted straight. USING EKC, COPIES CANNOT BE MADE AFTER PASSWORD IS ENTERED Check to see if the message EXCEEDS LIMIT is displayed. Contact Key Operator to reset limit. FINISHER DOES NOT OPERATE Touch OUTPUT MENU. Check for a paper misfeed and remove it, as required. Properly close finisher door. 5 Troubleshooting Call for Service Preventive Maintenance Clearing Mishandled Paper JAM Key RADF INDICATOR WILL NOT LIGHT AFTER [AUTO RESET] IS PRESSED Fully close RADF. RADF LIGHT IS FLASHING The document feeder is ready to accept originals. Insert originals on RADF tray, press [AUTO RESET], then [START]. ADD TONER MESSAGE IS DISPLAYED New toner supply is needed. Follow instructions for adding toner. ADD PAPER Key Memory Overflow Power OFF/ON Screen Copying Hints CALL FOR PM IS DISPLAYED IN MESSAGE AREA Contact your service representative for Preventive Maintenance. APS SELECTS THE WRONG COPY SIZE Paper guides must be adjusted exactly to the size of originals. IN MIXED ORIGINAL MODE, A MESSAGE TO LOAD A REQUIRED PAPER SIZE DISPLAYS, EVEN THOUGH THAT SIZE IS LOADED IN ONE OF THE TRAYS Paper sizes loaded in the trays must be consistent with the tray position size; otherwise, the tray key on the Basic Screen will blink. 5-15