Kyocera KM-8530 KM-8530 Operation Guide - Page 25

Environment Requirements for Safe Use (continued) 1 Safety Information CAUTION: Prevention of Fire Do not install near flammable materials, curtains and volatile combustibles, that can catch or cause fire. CAUTION: Prevention of Short Circuit Do not install the copier where it could be splashed with rain water, or water from a tap, to avoid a short circuit. CAUTION: Temperature and Humidity • Keep away from direct sunlight, heat sources such as stoves, cool air from an air conditioner and hot air from a heater. • Avoid any environment that is outside the range shown below: 50 to 86°F (10 to 30°C) in temperature 10 to 80% in humidity CAUTION: Ventilation • Maintain the installation place well-ventilated. • Keep away from dust or corrosive gases. These materials may cause poor image quality. • During the use of machine, the machine generates ozone in an insufficient amount to cause any hazard to the human body. However, if the machine is used in a poorly ventilated room, many copies are made, or more than one copier is used at the same time, an odor may be detected. Ensure adequate ventilation for a comfortable working environment. CAUTION: Vibration Do not install on a floor which is subject to vibration or is not level. CAUTION: Transportation Be sure to contact your service representative when moving or transporting the machine. If you move the machine with the Hard disk drive or Memory unit installed, machine trouble may be caused by vibration. 1-7