Kyocera KM-8530 KM-8530 Operation Guide - Page 75

Selecting Copy Size (continued) To Specify Desired Copy Size (AMS) When a copy size is specified on the touch screen, an appropriate reduction or enlargement ratio will be selected automatically according to the original size detected from the RADF or the platen glass. HINTS • See the table on the following page for the relation of original size, copy paper size, and magnification ratio automatically selected. • Wide paper size can be specified when AMS is in use. In this case, the same magnification ratio as that of the standard size will be selected automatically. • If copying in 1.00 (100%) magnification mode and specifying a copy size, see p. 3-15. 1. Touch a tray key on the Basic Screen to select the desired copy size. 3 Copying Operations Positioning Originals Setting Print Quantity Set Job During Warmup Stop Scan/Print Copy Size Lens Mode Density 1-1, 2-2 2-1 Selected tray key will be highlighted, and under the LENS MODE AMS indication will Multi-Sheet also be highlighted. Bypass Tray 2. Select additional copy conditions, as desired. Using Memory 3. Enter the desired print quantity from the control panel keypad. Output without Finisher HINT DF-630/635 Output Modes See p. 3-7 for details on setting print quantity. 4. Position original(s). Binding Mode Recalling Previous Job HINTS • See p. 11-8 to p. 11-10 for copy sizes detectable from the RADF or on the platen glass. • See p. 3-2 to p. 3-6 for details on positioning originals. Check Mode & Proof Copy Interrupt Mode 5. Press [START]. Scanned image will be printed on the specified copy size in the magnification ratio automatically selected. 3-13