Netgear WC7600 Reference Manual - Page 58
Deploy the Wireless Controller, Roadmap for Initial Configuration
View all Netgear WC7600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
ProSAFE Wireless Controller WC7600 Deploy the Wireless Controller After you have followed the steps in the Roadmap for Initial Configuration on page 54 and the Roadmap for Configuring Management of Your Wireless Network on page 55, you are ready to deploy the wireless controller in your network. To deploy the wireless controller: 1. Disconnect the wireless controller from the computer that you used for configuration. 2. (Optional) Reconfigure the computer back to its original TCP/IP settings. 3. Place the wireless controller where you intend to deploy it. 4. Connect an Ethernet cable from the wireless controller to a switch or router on your wired network. 5. Connect the power cord to the wireless controller and plug the power cord into a power outlet. The Power, Status, and Ethernet LEDs should light. If any of these do not light, see Troubleshoot Basic Functioning on page 296. Installation and Configuration Overview 58