Ricoh Aficio SP 5210SF Network Guide - Page 193
wsmfp, Configuration, Address configuration, NBT NetBIOS over TCP/IP scope ID selection
View all Ricoh Aficio SP 5210SF manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 193 highlights
Remote Maintenance Using telnet • If the IPv4 address obtained from DHCP differs from the WINS IPv4 address, the DHCP address is the valid address. Configuration msh> wins "interface_name" {on|off} • {on} means "active" and {off} means "inactive". • Be sure to specify the interface. • wlan can be specified only when the IEEE 802.11 interface is installed. Interface name Interface configured ether Ethernet interface wlan IEEE 802.11 interface 4 Address configuration Use the following command to configure a WINS server IP address: msh> wins "interface_name" {primary|secondary} "IP address" • Use the "primary" command to configure the primary WINS server IP address. • Use the "secondary" command to configure the secondary WINS server IP address. • Do not use "255.255.255.255" as the IP address. NBT (NetBIOS over TCP/IP) scope ID selection You can specify the NBT scope ID. msh> wins "interface_name" scope "ScopeID" • The scope ID can be entered using up to 31 alphanumeric characters. • Be sure to specify the interface. • wlan can be specified only when the IEEE 802.11 interface is installed. Interface name ether wlan Interface configured Ethernet interface IEEE 802.11 interface wsmfp Use the "wsmfp" command to view and configure the WSD (Device), WSD (Printer) and WSD (Scanner) settings. 191