Ricoh Aficio SP 5210SF Network Guide - Page 43
Specify WPA, when [Communication Mode] is set to [Infrastructure Mode]., Select either [WPA-PSK]
View all Ricoh Aficio SP 5210SF manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
Interface Settings (mainly North America) • IEEE 802.11 a/b/g Wireless LAN Frequency range: 2412 - 2462 MHz (1 - 11 channels) 1 5180 - 5240 MHz (36, 40, 44 and 48 channels) Default: [11] Security Method Specifies the encryption of the Wireless LAN. Default: [Off] If you select [WEP], always enter WEP key. If you select [WPA], specify the encryption and authentication methods. Specify "WPA", when [Communication Mode] is set to [Infrastructure Mode]. • WEP If you select [WEP], enter WEP key. When using 64 bit WEP, up to 10 characters can be used for hexadecimal and up to 5 characters for ASCII. When using 128 bit WEP, up to 26 characters can be used for hexadecimal and up to 13 characters for ASCII. The number of characters that can be entered is limited to 10 or 26 for hexadecimal and 5 or 13 for ASCII. • WPA • WPA Encryption Method Select either [TKIP] or [CCMP (AES)]. • WPA Authent. Method Select either [WPA-PSK], [WPA], [WPA2-PSK], or [WPA2]. If you select [WPA-PSK] or [WPA2-PSK], enter the pre-shared key (PSK) of 8- 63 characters in ASCII code. When [WPA] or [WPA2] are selected, authentication settings and certificate installation settings are required. For details about setting methods, see "Configuring IEEE 802.1X". Wireless LAN Signal When using in infrastructure mode, you can check the machine's radio wave status using the control panel. Radio wave status is displayed when you press [Wireless LAN Signal]. Restore Factory Defaults You can return the wireless LAN settings to their defaults. 41